SteelThumb

Procedure · OKF v0.2

Prepare a buried nagaimo pipe bed

Plus Y’s nagaimo-specific Clever Pipe preparation branch; Japanese buried garden-soil system, not a freestanding pot or jinenjo recipe.

Status: draft 6 claims License: MIT Rev: 54d2abbe6163 Raw OKF (.md) Source on GitHub

Prepare a buried nagaimo pipe bed

Purpose and prerequisites

Prepare the bed through marking and ridging; seed placement and the subsequent growing season are separate tasks. First read the crop identity and regional restrictions and pipe-method decisions. Confirm permitted cultivation, labeled nagaimo stock and the actual equipment instructions before purchasing or moving planting material.

Have the specified pipe and clips, mineral fill, marker rods, digging tools and enough accessible ground for excavation and eventual pipe removal. This preparation is not a soil-free growing system. Obtain the supplier's fill specification; ordinary garden soil has not been demonstrated pathogen-free by its appearance or collection depth.

Prepare the bed

Use the nagaimo pipe: approximately 105 cm long and 6.5 cm diameter.1

Fit both clips; fill 60–70% with unfertilized mineral soil.1

Dig a trench 25 cm wide and 30–40 cm deep.1

Set pipes at 10–15°, receivers upward and about 30 cm apart.1

Mound matching soil over receivers; put a vertical marker centrally in each.1

Build roughly 20 cm of soil above the pipes.1

Inspect before planting

Editorial checks: photograph receiver and marker positions before covering; record measured trench dimensions, pipe model and fill batch. Confirm that each marker stays aligned with its receiver and remains visible after ridging. If a marker moves, expose the receiver and restore alignment before using it to locate planting stock. Retain access to the buried equipment for later excavation.

This task ends with a mapped, prepared bed. Continue with pipe-specific seed placement, after resolving stock preparation, local season, fertility and irrigation. The harvest task owns equipment removal. These linked tasks do not yet form a complete whole-season care route or establish yield advantage or containment efficacy.

Crop hub · Source review.

Connected concepts (5)

Chinese yam — nagaimo

Dioscorea polystachya with an initial Japanese long-form nagaimo ground route and regional restrictions.

applies to · Crop
Inspect OKF v0.2 Claims & Evidence (6 claims, 1 sources)
#hardware recommendation pipe length: 105 cm (Approximate product length; diameter 6.5 cm in statement.)

Use the nagaimo pipe: approximately 105 cm long and 6.5 cm diameter.

Applicability: Plus Y’s nagaimo-specific Clever Pipe preparation branch; Japanese buried garden-soil system, not a freestanding pot or jinenjo recipe.

Evidence: supports via plusys-pipe (長芋の栽培方法 / クレバーパイプ長芋用)

#fill recommendation pipe fill fraction: 60–70 % (Approximate portion of pipe filled; supplier does not define compaction or wet/dry measurement.)

Fit both clips; fill 60–70% with unfertilized mineral soil.

Applicability: Plus Y’s nagaimo-specific Clever Pipe preparation branch; Japanese buried garden-soil system, not a freestanding pot or jinenjo recipe.

Evidence: supports via plusys-pipe (STEP1 steps 1–2 and POINT; material list)

#trench recommendation trench depth: 30–40 cm (Below surrounding ground; width 25 cm in statement.)

Dig a trench 25 cm wide and 30–40 cm deep.

Applicability: Plus Y’s nagaimo-specific Clever Pipe preparation branch; Japanese buried garden-soil system, not a freestanding pot or jinenjo recipe.

Evidence: supports via plusys-pipe (STEP1 step 3 and d21.png diagram)

#place recommendation pipe inclination: 10–15 degree (From horizontal as illustrated; receiver spacing approximately 30 cm.)

Set pipes at 10–15°, receivers upward and about 30 cm apart.

Applicability: Plus Y’s nagaimo-specific Clever Pipe preparation branch; Japanese buried garden-soil system, not a freestanding pot or jinenjo recipe.

Evidence: supports via plusys-pipe (STEP1 step 4; d3.png and d31.png)

#mark recommendation

Mound matching soil over receivers; put a vertical marker centrally in each.

Applicability: Plus Y’s nagaimo-specific Clever Pipe preparation branch; Japanese buried garden-soil system, not a freestanding pot or jinenjo recipe.

Evidence: supports via plusys-pipe (STEP1 steps 4–5 and d31.png)

#ridge recommendation ridge soil height: 20 cm (Above pipe/receiver level as diagrammed, not below-ground trench depth.)

Build roughly 20 cm of soil above the pipes.

Applicability: Plus Y’s nagaimo-specific Clever Pipe preparation branch; Japanese buried garden-soil system, not a freestanding pot or jinenjo recipe.

Evidence: supports via plusys-pipe (STEP1 step 6; d31.png and e1.png)