SteelThumb

Procedure · OKF v0.2

Plant and establish a medlar tree

UK ground planting and early care with general tree-depth guidance clearly identified.

Status: draft 10 claims License: MIT Rev: 54d2abbe6163 Raw OKF (.md) Source on GitHub

Plant and establish a medlar tree

Start with an identified medlar, suitable nursery rootstock/cultivar, water, spade, stake and tree tie. Resolve eventual canopy spread and tree-specific support before laying out the site. Use suitable unfrozen, non-waterlogged ground; this route does not remediate an unsuitable soil or transplant a mature tree.

Plant dormant trees in a sheltered sunny site with deep, fertile, well-drained soil.1

RHS advises at least 5 m clearance from other trees or buildings.1

Soak bare roots about 30 minutes; water potted stock before removal.2

Spread bare roots; trim potbound roots and leave other rootballs undisturbed.2

Dig no deeper than the roots and ideally at least three times their diameter.2

Depth decision: an older MSU medlar bulletin reports buried-graft advice that has not been reconciled with this general root-flare approach. Resolve the actual scion/rootstock and planting landmarks with the nursery before performing this step. See regional evidence and the current supplier comparison: deliberate scion rooting and an above-ground graft are different intended routes.

Set the first root flare at finished soil level.2

Backfill around roots, firm gently and water in.2

Install a sturdy stake at planting.1

Water during dry spells in the first growing season and prolonged dry spells in the following two years.1

Apply 5–7.5 cm organic mulch in late winter or early spring, keeping the trunk clear.1

The general RHS tree instructions supply root handling and planting depth. Distinguish root flare from graft swelling; ask the nursery to identify obscured landmarks before planting. Do not copy a graft height from another fruit. Select support without changing the final root level, and retain access for inspection.

Observe establishment

Editorial follow-up: record label, planting date, root flare, support, moisture and new growth. Recheck settling, lean and tie fit. Distinguish wet lower soil from a dry rootball before responding to wilt; an apparently dry surface is insufficient evidence. Refer persistent decline or unexplained dieback for diagnosis.

Formative pruning and nutrition remain separate decisions. Do not infer a fertilizer deficit from slow establishment alone. Obtain a tree-specific pruning plan before removing framework growth. The eventual harvest/bletting task begins only when fruit meets its stage cues; no first-harvest year is promised. Container and controlled-system establishment remain unreviewed. Evidence scope.

Connected concepts (2)

Medlar

Common medlar with UK ground establishment and harvest-to-bletting guidance.

applies to · Crop
Inspect OKF v0.2 Claims & Evidence (10 claims, 2 sources)
#site recommendation

Plant dormant trees in a sheltered sunny site with deep, fertile, well-drained soil.

Applicability: RHS UK common-medlar home-garden guidance; nursery tree in ground, not a universal climate or cultivar protocol.

Evidence: supports via rhs-medlar (Planting)

#clearance recommendation minimum clearance: 5 m (UK canopy planning distance, not a container dimension or universal orchard spacing.)

RHS advises at least 5 m clearance from other trees or buildings.

Applicability: RHS UK common-medlar home-garden guidance; nursery tree in ground, not a universal climate or cultivar protocol.

Evidence: supports via rhs-medlar (Planting)

#prepare recommendation bare root soak: 30 min (Preplant soak, not repeat irrigation.)

Soak bare roots about 30 minutes; water potted stock before removal.

Applicability: General RHS tree planting applied explicitly to a nursery medlar; ground route.

Evidence: supports via rhs-tree-plant (Guide to planting)

#roots recommendation

Spread bare roots; trim potbound roots and leave other rootballs undisturbed.

Applicability: General RHS tree planting applied explicitly to a nursery medlar; ground route.

Evidence: supports via rhs-tree-plant (Guide to planting)

#hole recommendation hole width factor: 3 ratio (Ideal minimum diameter relative to root-system diameter.)

Dig no deeper than the roots and ideally at least three times their diameter.

Applicability: General RHS tree planting applied explicitly to a nursery medlar; ground route.

Evidence: supports via rhs-tree-plant (Guide to planting)

#depth recommendation

Set the first root flare at finished soil level.

Applicability: General RHS tree planting applied explicitly to a nursery medlar; ground route.

Evidence: supports via rhs-tree-plant (Guide to planting)

#backfill recommendation

Backfill around roots, firm gently and water in.

Applicability: General RHS tree planting applied explicitly to a nursery medlar; ground route.

Evidence: supports via rhs-tree-plant (Guide to planting)

#support recommendation

Install a sturdy stake at planting.

Applicability: RHS UK common-medlar home-garden guidance; nursery tree in ground, not a universal climate or cultivar protocol.

Evidence: supports via rhs-medlar (Staking)

#water recommendation

Water during dry spells in the first growing season and prolonged dry spells in the following two years.

Applicability: RHS UK common-medlar home-garden guidance; nursery tree in ground, not a universal climate or cultivar protocol.

Evidence: supports via rhs-medlar (Plant Care — Watering)

#mulch recommendation mulch depth: 5–7.5 cm (Surface mulch layer, not planting depth.)

Apply 5–7.5 cm organic mulch in late winter or early spring, keeping the trunk clear.

Applicability: RHS UK common-medlar home-garden guidance; nursery tree in ground, not a universal climate or cultivar protocol.

Evidence: supports via rhs-medlar (Plant Care — Mulching)