SteelThumb

Procedure · OKF v0.2

Care, water management, disease diagnostics, and sanitation for Agaricus bisporus

Procedure reference profile in SteelThumb Almanac.

Status: draft 6 claims License: MIT Rev: 54d2abbe6163 Raw OKF (.md) Source on GitHub

This care and diagnostics procedure applies to button, cremini, and portobello mushrooms (Agaricus bisporus) (cultivated fungi fruiting bodies, not true plants).

Purpose

Maintain casing moisture between breaks without wetting cap surfaces long enough to invite bacterial blotch, separate visually overlapping mushroom diseases accurately, block sticky-spore and vector spread between flushes, and sanitize empty growing spaces between crops.537

Prerequisites

  • Working hygrometer/thermometer and fresh-air heating/cooling capacity to prevent dewpoint condensation on cooling mushroom caps.5
  • Spot-treatment supplies (coarse salt, 15% HTH, or 80% alcohol, noting organic certification rules exclude synthetic chlorine sanitizers where prohibited), low-pressure wash hoses, and floor squeegees (never dry brooms or high-pressure floor sprayers during active fruiting).36

Steps

1. Irrigate Casing Without Leaving Caps Wet

  • Maintain moisture without condensation: Water the casing layer between flushes using fine sprays sized so the casing stays spongy moist while mushrooms and compost never waterlog; ensure compost entering spawning held at least 62% moisture, since dry compost preconditions subsequent crops to blotch.15
  • Dry caps quickly (<4 hours): After any watering over pins or developing caps, stimulate evaporation immediately by introducing cool fresh air then warming the room air slightly (for example with 110–120 F perimeter heat pipes or gentle dehumidified air movement) so liquid films never remain on caps for 4–6 hours or more.56 For conventional operations experiencing persistent blotch, 150 ppm sodium hypochlorite in irrigation water reduces surface Pseudomonas fluorescens populations only when combined with drying conditions—never rely on chlorine while caps remain wet.5

2. Inspect Pins and Mature Caps Before Every Pick (Triage Table)

Inspect beds before pickers or watering hoses enter so infected zones are isolated first:

Disorder & Causal Agent Distinguishing Field Symptoms Immediate Action & Vector
Dry Bubble (Verticillium / Lecanicillium fungicola) Early infection: distorted globe mass with few or no amber drops; mid-stage: bent/split stipes ("blowout"); late infection: dark brown necrotic cap blotches with fuzzy gray center One cap emits 30 million spores/hr; do not touch or hose-splash (60 drops splash 2 ft); cover early bubbles 4–6 in wide with salt / 15% HTH / 80% alcohol; control phorid/sciarid flies & mites 3
Wet Bubble (Mycogone perniciosa) Misshapen spongy masses exuding numerous large amber liquid droplets Separate from dry bubble cleanly; spot-cover early, avoid splash/flies, verify Phase II & casing hygiene 3
Bacterial Blotch (Pseudomonas fluorescens biotype G) Superficial (2–3 mm deep) circular/irregular lesions on cap surface turning pale yellow -> golden yellow -> rich chocolate brown, lacking fuzzy gray fungal center Stop condensation on caps, dry surfaces <4 h, avoid over-watering prior to picking, harvest before open-cap spore load 56
Bacterial Mummy (Pseudomonas spp.) Stunted growth, curved stipes with translucent longitudinal streaks, spongy/dry/leathery tissue; 1st break may harvest, then 2nd break fails completely in patch Check Phase II completeness, avoid over-dense wet compost and extra water at spawning 69
Green Mold (Trichoderma harzianum Th4) Dense white mycelium erupting in heavy dark green sporulation on casing/compost, leaving bare dead black patches and brown lysed pins/rhizomorphs Tighten Phase II uniformity (avoid 160 F overshoot or anaerobic pockets), exclude dust/personnel vectors, salt/cover early spots, post-crop steam-off 42
LaFrance Virus (mycovirus) Mild: small/poorly sizing portobellos, bare patches, premature open veils; severe: "drumsticks" (tiny cap, elongated stem), weak disappearing casing mycelium, fast cut-stem discoloration Carried in live spores (40 million spores/hr per 3" open cap) and residual bed mycelium; pick before caps open, positive air pressure at spawning/casing, double steam-off 61

(Note: Never water at spawning if mummy disease appeared in recent cycles.9)

3. Slow Active Bubble Outbreaks Without Spreading Inoculum

  • Isolate and cool: On heavy dry-bubble pressure, drop air temperature from 68 F (20 C) toward 57 F (14 C) and lower RH from 90% to 80% to retard lesion expansion.3
  • Eliminate dust and splash: Clean floors with a squeegee and dampened disinfectant rather than sweeping with brooms or blasting with high-pressure hoses; assign clean-room pickers to youngest beds before older/infected rooms, and cover salt-treated bubbles early before pickers brush past them.3

4. End-of-Crop Dual Steam-Off & Spent Substrate Management

  • Steam with substrate in place: Close the room after 3–4 breaks (or sooner if Trichoderma or virus strikes) and steam-pasteurize compost to at least 150 F (66 C) for >=12 hours (8–24 hours overall guideline in Basic Procedures; research shows substrate cores take roughly 14 hours to reach 140 F / 60 C), killing adult sciarid/phorid flies, larvae, mites, spores, and viruses.71
  • Steam empty wooden beds/trays: Empty and pressure-wash/clean the beds, then steam the empty room again at 150 F (66 C) for at least 24 hours so heat penetrates damp bed wood (cypress wood heats 5–6× slower than substrate).7
  • Weather spent mushroom substrate (SMS): Never apply fresh SMS directly around salt-sensitive garden seedlings or transplants—fresh SMS carries elevated soluble salts (Na 0.21–0.33%) and high electrical conductivity (EC); weather composted piles outdoors with rainfall/leaching for at least 6 months (pH stabilizes near ~7.1 across 16-month weathering trials).18

Follow-up

Record flush-by-flush disorder locations and Phase II probe logs so any Trichoderma bare zone, mummy streak, or premature veil opening guides adjustments on the next Phase II batch and pick timing in Harvest & Postharvest.

Limits

  • Post-crop steam-off guidelines assume insulated steam-tight rooms; small poly-tub or closet grows should bag and solarize/compost spent blocks away from clean spawn areas and wash shelves with food-safe quaternary/bleach/peroxide cleaners rather than attempting open steam near living spaces.7

Footnotes


  1. Penn State Extension — Basic Procedures for Agaricus Mushroom Growing (https://extension.psu.edu/basic-procedures-for-agaricus-mushroom-growing). ↩↩↩↩

  2. Penn State Extension — Growing Mushrooms: Microbial Activity in Substrate (https://extension.psu.edu/growing-mushrooms-microbial-activity-in-substrate). ↩

  3. Penn State Extension — Verticillium Dry Bubble (https://extension.psu.edu/verticillium-dry-bubble). ↩↩↩↩↩↩

  4. Penn State Extension — Green Mold of Mushrooms (https://extension.psu.edu/green-mold-of-mushrooms). ↩

  5. Penn State Extension — Bacterial Blotch Disease (https://extension.psu.edu/bacterial-blotch-disease). ↩↩↩↩↩↩

  6. Penn State Extension — Basic IPM Practices for Organic Mushroom Farms: Bacterial and Viral Diseases of Mushrooms (https://extension.psu.edu/basic-ipm-practices-for-organic-mushroom-farms-bacterial-and-viral-diseases-of-mushrooms). ↩↩↩↩↩

  7. Penn State Extension — Best Practices for Mushroom Post-Crop Sanitation: Steam-Off/Post-Crop Pasteurization (https://extension.psu.edu/best-practices-for-mushroom-post-crop-sanitation-steam-off-post-crop-pasteurization). ↩↩↩↩

  8. Penn State Extension — Spent Mushroom Substrate (https://extension.psu.edu/spent-mushroom-substrate). ↩

  9. Penn State Extension — Seeding Substrate and Management of Growing Agaricus bisporus (https://extension.psu.edu/seeding-substrate-and-management-of-growing-agaricus-bisporus). ↩↩

Connected concepts (3)

Inspect OKF v0.2 Claims & Evidence (6 claims, 9 sources)
#care-bcp-wet-cap-blotch-rule recommendation blotch wet cap trigger duration: 4–6 hour

Dry mushroom cap surfaces promptly after irrigation by gently cooling and reheating air slightly (or raising air circulation) so free moisture never sits on caps for 4 to 6 hours or longer, which triggers superficial Pseudomonas bacterial blotch; optionally add 150 ppm sodium hypochlorite in irrigation water only in combination with cap-drying airflow.

Evidence: supports via psu_blotch; qualifies via psu_ipm_organic

Distinguish Verticillium (Lecanicillium) dry bubble from Mycogone wet bubble by surface exudate and deformation: dry bubble creates irregular undifferentiated globes with few or no amber drops alongside split stipes or brown spots with gray fuzzy centers, whereas wet bubble produces numerous large amber drops over malformed tissue.

Evidence: supports via psu_dry_bubble

#care-bcp-dry-bubble-suppression recommendation dry bubble suppression air temp: 57 degF

Suppress active dry bubble outbreaks without splashing sticky spores (60 water drops splash spores up to 2 feet) by covering isolated bubbles with a 4 to 6 inch ring of salt, 15 percent HTH, or 80 percent alcohol without touching the lesion, lowering air temperature from 68 to 57 degrees F (20 to 14 degrees C) and RH from 90 to 80 percent, and squeegeeing floors rather than dry sweeping or high-pressure hosing.

Evidence: supports via psu_dry_bubble

Separate casing-patch green mold (Trichoderma harzianum Th4: dense white mats turning dark green sporulation with bare black casing zones and brown lysed pins), bacterial mummy (Pseudomonas: stunted curved stipes with longitudinal translucent streaks, dry leathery spongy flesh, and absent second break), and LaFrance virus (drumstick caps on long stems, premature open veils, fast stem browning when cut, and spore-borne persistence).

Evidence: supports via psu_green_mold; supports via psu_ipm_organic

#care-bcp-postcrop-steam-off recommendation post crop empty room steam duration: 24 hour

Execute dual post-crop steam-off pasteurization after the final flush: steam closed rooms with substrate in place to at least 150 degrees F (66 degrees C) for at least 12 hours (noting internal compost needs roughly 14 hours to reach 140 degrees F), then clean and empty the room and steam empty beds again at 150 degrees F for at least 24 hours so heat penetrates wooden bed boards.

Evidence: supports via psu_steam_off; qualifies via psu_basic_agaricus

#care-bcp-sms-weathering recommendation sms minimum weathering period: 6 month

Weather fresh spent mushroom substrate (SMS, fresh sodium 0.21 to 0.33 percent and high soluble salts) outdoors for at least 6 months before incorporating near salt-sensitive garden crops or seedlings.

Evidence: supports via psu_basic_agaricus; supports via psu_sms