Select and train Masui Dauphine fig fruiting shoots
Use established Masui Dauphine fig plants already formed into the cited horizontal-arm system, with winter pruning completed and serviceable supports. This task starts at new-shoot selection. It does not establish the initial trunk/arms or prescribe winter cuts, wound treatments or support engineering.
Select replacement fruiting shoots when new growth has three to four leaves.1
Retain one shoot per approximately 40 cm on each side of the horizontal arm.1
Prefer lateral or slightly downward buds and remove unwanted upward growth.1
Repeat shoot selection over two to three passes as later buds grow.1
At eight to ten leaves, let shoots extend sideways 10–15 cm before guiding them upward along supports.1
Pinch the shoot tip when the fruiting shoot has eighteen to twenty nodes.1
Editorial execution: identify each arm and distinguish its two sides before marking retained shoots. Remove competing buds while small without damaging the selected growth. Guide retained shoots to the existing horizontal support, then upward as they extend; use ties that hold without constricting, and recheck contact and growth. Count nodes on the actual fruiting shoot before removing its soft tip. These tie/inspection details are editorial; no exact tie product or force was tested here.
Record selected positions, developmental stage, training and tipping dates. Reinspect later competing growth and any bends or tie injury. Do not apply the UK bush five-to-six-leaf pinching routine to these shoots: the plant form, regional crop strategy and intended stage differ.
This regional task assumes the established structure is correctly identified. A young plant, container bush, damaged scaffold or unverified cultivar needs a separate plan. Continue with Japanese care and maturity guidance. Source inspection records prose/diagram agreement and excluded fertilizer directions. No observed efficacy or yield is claimed.