Dig and handle long-form nagaimo at harvest
Purpose and preparation
For identified, permitted long-form nagaimo grown under the planting route. Have a spade, cutting tool, collection surface and cover. Identify the planting position and allow working room. This is a physical lifting task, not a storage or food-safety protocol.
Harvest when leaves have yellowed fully and the whole plant is beginning to die back.1
Choose a run of fine weather rather than digging excessively wet soil after rain.1
Cut vines 5–6 cm above the tuber neck and clear the foliage.1
Start about 30 cm from the plant with an upright spade; excavate gradually below the tuber tip before lifting carefully.1
Keep lifted tubers covered against direct sun and strong wind while removing them from the field.1
Check and follow up
Editorial record: note foliage stage, soil condition, cultivar, digging damage and whether the tuber tip was exposed before lifting. If repeated breakage occurs, review excavation access and technique before digging the next plant. Separate damaged material for assessment; these instructions do not establish a safe storage duration or make rotten tubers edible.
The source's readiness cue differs from Takii's later fully dried stem sequence. Follow this named route without treating both cues as identical or assigning one global maturity date. Ground overwintering needs local evidence; no frost-survival assurance is transferred here. Retain loose bulbils and tuber pieces and consult locally applicable disposal guidance, as described by the crop's spread warning.