SteelThumb

Procedure · OKF v0.2

Grow watercress with a floating cover

Partial single-crop hydroponic route with explicit commissioning and food-safety prerequisites.

Status: draft 6 claims License: MIT Rev: 54d2abbe6163 Raw OKF (.md) Source on GitHub

Grow watercress with a floating cover

Scope and prerequisites

This draft selects the floating-cover branch and a single harvest followed by reset. It is a distinct route from potting-mix culture. It is partial until the setup inputs below are resolved; no edible-production commissioning or field validation is claimed.

Before starting, obtain labeled Nasturtium officinale seed, suitable tank/cover/net-pot materials, a complete hydroponic nutrient product with usable dilution instructions, pH measurement equipment and a documented water supply. Resolve actual material suitability with suppliers; a generic construction-material name does not certify the purchased product for this use. The nutrient product must provide mixing and correction directions for the actual source water. No EC target is supplied here: the source prints abbreviated conductivity units, and their measurement basis needs clarification before importing a meter setting.

Choose and document a net-pot layout before cutting the cover. Exact hole coordinates and small-tank scaling are still research inputs; this page supplies no optimum stocking density. Ensure the cover can move vertically without catching. This is an editorial commissioning check, not a tested tank design. Confirm structural support for the filled tank before filling it.

Supported steps

Use a tank at least 5.5 inches deep.1

Float ½–1-inch extruded-polystyrene covers; immerse the lower 1–1½ inches of net pots.1

Surface-sow 10–20 seeds per 2-inch net pot filled with peat–perlite medium.1

Prepare complete hydroponic fertilizer according to its manufacturer; monitor solution pH, generally 5.5–6.5.1

Cut 8–12-inch stems with scissors; retain at least 2 inches of tank solution.1

Clean the tank and replace its solution before replanting.1

Commission, observe and investigate

Editorial checklist: test the assembled tank for leakage and confirm that the medium wets at the seed surface before sowing. Record the nutrient product, dilution, actual fill volume, water source, pot arrangement, dates and pH readings. Record the growing site's air and solution temperatures; a complete local climate-control specification remains missing.

Inspect water level, float movement, wetting, emergence and roots. If the medium dries, distinguish a jammed cover or lost water from a failure of the chosen medium to wick. Repair the physical fault and observe new growth. If pH seems abnormal, check the instrument before following the nutrient manufacturer's correction instructions; no acid/base dose is inferred here. Compare with the existing leaf-pest checks when damage is on leaves. Root disease, mosquitoes or unexplained decline need an applicable local diagnosis/control method before continuing this route; no pesticide or fish addition is prescribed.

Harvest instructions describe physical cutting, not safe raw consumption. Apply the watercress food boundary. A documented water-quality, pest-exclusion, equipment-cleaning and produce-handling plan remains necessary; rinse frequency, clear water and vigorous growth do not establish those controls. Obtain a suitable cleaning product's current label before reset; no disinfectant concentration or contact time is established here.

Do not transfer these settings to lettuce, fish systems, aeroponic chambers or the separately described suspended-pot route. Repeated ratoon harvest, yield forecasting, cooling, lighting and nutrient recycling remain separate research tasks.

Crop · Sources.

Connected concepts (2)

Watercress

Nasturtium officinale container growing, with water-source and harvest-safety boundaries.

applies to · Crop
Inspect OKF v0.2 Claims & Evidence (6 claims, 1 sources)
#tank recommendation minimum tank depth: 5.5 in (Tank depth, not initial solution depth.)

Use a tank at least 5.5 inches deep.

Applicability: CTAHR VC-7 (2015), floating-cover watercress method developed in Hawaii; not an aquaponic or aeroponic protocol.

Evidence: supports via ctahr-watercress-vc7 (Tanks, page 6)

#float recommendation net pot immersion: 1–1.5 in (Lower pot portion in floating-cover branch; cover thickness separately in statement.)

Float ½–1-inch extruded-polystyrene covers; immerse the lower 1–1½ inches of net pots.

Applicability: CTAHR VC-7 (2015), floating-cover watercress method developed in Hawaii; not an aquaponic or aeroponic protocol.

Evidence: supports via ctahr-watercress-vc7 (Floating-Cover Method, page 5)

#sow recommendation seeds per net pot: 10–20 seed (Per 2-inch net pot; seeds are uncovered.)

Surface-sow 10–20 seeds per 2-inch net pot filled with peat–perlite medium.

Applicability: CTAHR VC-7 (2015), floating-cover watercress method developed in Hawaii; not an aquaponic or aeroponic protocol.

Evidence: supports via ctahr-watercress-vc7 (Planting Density, page 8; Propagating Watercress From Seed, page 13)

#nutrient recommendation nutrient solution pH: 5.5–6.5 pH (General non-circulating guidance, not a tested universal optimum.)

Prepare complete hydroponic fertilizer according to its manufacturer; monitor solution pH, generally 5.5–6.5.

Applicability: CTAHR VC-7 (2015), floating-cover watercress method developed in Hawaii; not an aquaponic or aeroponic protocol.

Evidence: supports via ctahr-watercress-vc7 (Fertilizer, page 9; pH, page 12)

#harvest recommendation harvest stem length: 8–12 in (Stem length, not retained stubble; minimum remaining solution depth separately in statement.)

Cut 8–12-inch stems with scissors; retain at least 2 inches of tank solution.

Applicability: CTAHR VC-7 (2015), floating-cover watercress method developed in Hawaii; not an aquaponic or aeroponic protocol.

Evidence: supports via ctahr-watercress-vc7 (Harvesting, page 15; Floating-Cover Method, page 5)

#reset recommendation

Clean the tank and replace its solution before replanting.

Applicability: CTAHR VC-7 (2015), floating-cover watercress method developed in Hawaii; not an aquaponic or aeroponic protocol.

Evidence: supports via ctahr-watercress-vc7 (Floating-Cover Method, page 5; After Harvesting, page 17)