Establish a wine cap bed
Have the specified spawn product, known untreated hardwood material, water, a ruler and a measured site. Confirm the supplied bag and current instructions match this route before using its area rate; obtain the supplier rate for other bag sizes. No spawn-mass conversion is possible from the inspected page.
Select the local seasonal window before opening spawn. Then prepare the site, measure its area, build the lower layer, distribute spawn, cover and water as below.
Use clean, untreated hardwood chips or sawdust; avoid branches and very large pieces.1
Choose partial shade and clear debris to bare ground or grass so the bed contacts soil.1
The cited spawn bag inoculates approximately 16 square feet.1
Spread about 1 inch of woody substrate, then crumble spawn evenly over it.1
Cover spawn with 2–3 inches of woody substrate and water thoroughly.1
North Spore advises inoculation after average daytime temperatures exceed freezing and at least four weeks before frost.2
Record actual bed area, layer depths, wood origin and date, then follow bed care. Compare the setup with this route if establishment fails; do not assume inoculation guarantees colonization.
Route boundary
This selects the product-page shallow bed. The same supplier's article describes a deeper alternating-layer bed; it is an alternative, not additional layers to append here. The hardwood-only selection avoids their differing mixed-wood proportions. See source notes before adapting. No pasteurization, fertilizer or universal watering volume is prescribed by this procedure.